The Ultimate Guide to Cutting

The Advantages of Waterjet Cutting Technique

Waterjet cutting has a number of benefits that it comes with and these should actually be known to all, those who are well familiar and already using this technique and even for those who may be new to the same. Read on in this post and see some of the benefits of waterjet cutting as a technology so as to enable you as a business person to make such an informed business decision going forward.

Talking of waterjet cutting, one thing that should be well understood is that there are two kinds of waterjet cutting techniques and these are the pure waterjet cutting and the abrasive waterjet cutting. When it comes to the pure waterjet cutting, this just as the name suggests is the kind of technique in which there is solely used water streams for cutting and is most commonly applied for cutting soft materials like foam and paper. When it comes to the abrasive waterjet cutting, this is one that sees the addition of granular abrasives to the water streams used for the cutting. With the addition of these granular abrasives, there will be accelerated the power of the cutting and as well the speed which makes the cutting even of the hard materials like ceramics and metals a lot easier.

Check out the following for some of the benefits that come with the waterjet cutting techniques and improve your general knowhow of the technology so as to be able to make better business decisions.

The first of the benefits of the waterjet cutting is in the fact that it is applicable on a wide range of materials all ranging from such materials as rubber, composites, metals, glass, stone or rock, ceramics, plastics, et cetera. By the way, where you even add the granular abrasives, you will see a waterjet cutting technology cut materials as thick as 200mm.

One more benefit of waterjet cutting is the fact that with it, there will be no issues of heated affected zones on the cut materials. This is as a result of the cold cutting method applied in it which as well has the benefit of increasing the operator’s safety as there are no chances of burns. Over and above this, the cold cutting technology as well is as good as it helps you limit the cases of material distortion as a result of the fact that the heat is bypassed and as such so good for the cutting of such materials like metals which may be affected by such heats on them while being worked on for cutting. As a matter of fact, where you choose waterjet cutting as your preferred method for cutting, you can be well assured of such clean and smooth cuts, free of any burring effects on them.

Why People Think Cutting Are A Good Idea

The Key Elements of Great Waterjets